Waterous Pressure Governor, Инструкция по установке и эксплуатации

Страница: 39 / 53

39
|
53
Safety Introduction Product Overview Installation Operation
Configuration Settings
Name Name Description Description Default Default Level Level
1 UNITS Displayed units of measure in PSI/°F, kPa/°C, MPa/°C, or bar/°C. PSI/F User
2 PRESET RPM Preset button speed in RPM when in speed mode. Choose from: 900 to 1500 RPM in increments of 25. 1000 User
3 PRESET PSI Preset button pressure when in pressure mode. Choose from: 90 to 130 PSI in increments of 10. 90 User
4 HIGH IDLE Engine speed in RPM when in high idle mode. Choose from: 900 to 1400 RPM in 25 RPM steps. 1100 User
5 SENSITIVITY Engine speed is not adjusted until difference between set-point and actual pressure in PSI is greater than the
sensitivity value. Choose from: 2 to 10 PSI.
5 User
6 RPM GAIN Change in engine speed in RPM for each button press of knob detent. Choose from: 1 to 30. 15 User
7 PRESS GAIN Change in pump pressure in PSI for each button press or knob detent. Choose from: 1 to 10. 5 User
8 ALLOW
PRESET
Enable or disable operation of speed mode preset button when pump pressure is greater than 10 PSI.
Choose: yes or no.
No User
9 SMOOTHING Number of samples used in the averaging of the pressure sensor measurement. Choose: from no, low, or high. No User
10 PSET MIN Minimum pump discharge pressure in PSI before the preset button will operate in pressure mode. Choose
from: 0 to 100 PSI in increments of 5.
25 User
11 NUDGE LIMIT Engine speed is not adjusted until difference between speed set-point and actual engine speed is greater than
the nudge limit value. Choose from: 0 to 25 RPM in increments of 5.
15 User
12 LAG DELTA PSI Engine speed is not adjusted until the difference between pressure set-point and actual pressure is greater
than the lag delta PSI value. Choose from: 1 to 5 PSI.
1 User
13 ROUNDING Enable or disable rounding of the pressure or speed displays. Choose from: no, PSI, RPM, or both. No User
14 IDLE RPM Idle mode engine speed in RPM. Choose from: 600 to 900 RPM in increments of 25. Note: The speed must
be greater than the engines curb idle speed.
No User
15 PSI TIME-OUT Number of seconds that the pressure can be below 30 PSI in pressure mode. Choose from: 3 to 10 seconds. 3 User
16 DISCHARGE
SENSOR
Discharge sensor full scale pressure. Choose from: 300 or 600 PSI. Note: Set the value to 300 PSI for a
single-stage pump, and 600 PSI for a two-stage pump.
300 User
17 INTAKE
SENSOR
Intake sensor full scale pressure. Choose: 300 or 600 PSI. 300 Service
18 DIS. 0 CAL Calibrates the discharge sensor 0 PSI value. Press the preset button with discharge at 0 PSI to run the
calibration.
—
Service