Waterous Pressure Governor, Инструкция по установке и эксплуатации

Страница: 37 / 53

37
|
53
Safety Introduction Product Overview Installation Operation
Configuring the Pressure Governor—Service Configuration Mode
1
2
3
4
5
6
Use the illustration and instructions to open the
service configuration mode, change parameters,
and exit the configuration mode. Configure the
pressure governor with the appropriate parameters
for your application. For a description of the
available parameters in this mode, refer to:
"Configuration Settings" on page 39
.
The service configuration mode gives you access to
the service level settings, as well as the user level
settings. Follow the instructions below to access the
service configuration mode.
1 From ready mode, press and hold the
Idle
or
Status
button while entering the password
sequence as shown.
2 The RPM display shows P and the selected
parameter number when in the configuration
mode.
3 Use the
PSI
and
RPM
buttons to change the
parameter number.
4 Use the
+
and – buttons or the
Rotary Knob
to
change the parameter value.
5 Press the
Preset
button to store the parameter
value.
6 Press the Idle or Status button to exit the
configuration mode.