Waterous Pressure Governor, Инструкция по установке и эксплуатации

Страница: 40 / 53

40
|
53
Safety Introduction Product Overview Installation Operation
Configuration Settings
Name Name Description Description Default Default Level Level
19 INT. 0 CAL Calibrates the intake sensor 0 PSI value. Press the preset button with intake at 0 PSI to run calibration. — Service
20 DIS. OFFSET Calibrates the discharge sensor at a known pressure. Use the +/– buttons or knob controls to set the menu to
the applied pressure. Press the preset button to run the calibration.
Note: The static pressure calibration point
must be within 20% of the full sensor value.
—
Service
21 INT. OFFSET Calibrates the discharge sensor at a known pressure. Use the +/– buttons or knob controls to set the menu to
the applied pressure. Press the preset button to run the calibration. Press the preset button to run the
calibration.
Note: The static pressure calibration point must be within 20% of the full sensor value.
—
Service
22 ENGINE TYPE Engine control type. Choose from: Cummins FPG, J1939 PGN0, Scania, Volvo, Mercedes, or, analog. Cummins OEM
23 BRIGHTNESS Adjusts display brightness. Automatic adjusts the brightness depending on ambient light conditions. Choose
from: 1 to 10 manual setting or automatic.
Automatic User
24 DISPLAY TEST Turns on all front panel LED indicators and display pixels for 2 seconds. Press the preset button to start the
display test.
—
User
25 ALERT TONE Enables or disables the double beep alert tone. Choose: yes or no. Yes User
26 DISPLAY Changes the numerical display to either RPM mode or a pressure set-point. Choose: RPM or PSI SET. RPM Service
27 VOLT OFFSETS Offset that is applied to the battery voltage display. Choose from: –0.5 to 0.5 VDC in increments of 0.1. 0.0 Service
28 KNOB INC
DIRECTION
Adjusts which knob direction causes an increase. Choose: CW or CCW. CW User
29 COM STATUS Displays the CAN bus engine speed message count or number of errors. — Service
30 BAUD RATE Adjusts the CAN bus engine control speed. Choose from: 250K, 500K or automatic. 500K Service
31 FACTORY
DEFAULT
Returns all of the configuration parameters to their factory defaults. Press the preset button to set all
parameters to default.
—
Service
32 ENGINE ID Configures the CAN bus source address of the engine. Choose from: 0 to 255. 0 OEM
33 DAY Sets the real-time-clock day of the month. Choose from: 1 to 31. 1 User
34 MONTH Sets the real-time-clock month of the year. Choose from: 1 to 12. 1 User
35 YEAR Sets the real-time-clock year. Choose from: 2000 to 3000. 2018 User
36 HOUR Sets the real-time-clock hour of the day. Choose from: 0 to 23. 0 User
37 MINUTE Sets the real-time-clock minute of the hour. Choose from: 0 to 59. 0 User
38 PUMP HOURS Changes the pump hours value. Use the +/– buttons or knob controls to adjust the pump hours setting. Press
the preset button to run the calibration.
0 Service