Vorwerk KOBOLD VR200, Инструкция по эксплуатации

Страница: 48 / 56

48 Troubleshooting
fault PossIble cause and elImInatIon
The Kobold VR200 robot vacuum does
not return to the base station after
cleaning.
If the faults cannot be elimi-
nated, contact Vorwerk Cus-
tomer Service (see Section
“9 Service” on page 53).
For more information, visit:
www.vorwerk.
com.au
• Check whether the protective film on the infrared window of the base station has
been removed.
You many have started the cleaning process in normal mode from a location other
than the base station.
If you start the robot vacuum at a different location in the room, it returns there after
cleaning.
Cleaning may have been interrupted, and the robot vacuum could have been switched
back on in a different place in the room.
The sensors on the base station or several sensors on the robot vacuum may be
covered or dirty (see Section “4.5 Cleaning the robot vacuum and the base station” on
page 42).
• Remove the objects covering the sensors on the robot vacuum and clean the sensors.
The base station may be located behind a wall or other obstacle that is blocking the
signal.
• Set up the base station in a different location.
• Make sure that there are no obstacles within 0.5 metres on both sides of the base
station.
You may have cleaned an area using spot cleaning mode.
Once the robot vacuum has cleaned the area, it automatically stops in the starting
position. In normal cleaning mode, the robot vacuum automatically returns to the
base station.
The base station setup may not be optimal.
Test whether the base station setup is optimised:
• Start spot cleaning from the base station. If the robot vacuum cannot find the base
station afterwards, it is poorly set up. Try again in a different location.