39
Maintenance
4.1.3 reinstalling the dust container and fi lter
•
Insert the filter back into the dust container
11
.
•
Insert the dust container with filter
12
back into the Kobold VR200 robot vacuum.
•
Press down the dust compartment cover
13
and ensure that it is properly closed.
Notice! Risk of damage due to improper use!
•
Never operate the device without the filter.
4.2
cleaning the side brush
Warning! Risk of electric shock!
•
Always switch off the device and disconnect the mains plug before all
changeover, cleaning and maintenance tasks.
The side brush is easy to pull off the mounting point.
•
Pull the side brush up and off the drive axle
1
by the green bristles,
2
using
both hands.
•
Clean dust and dirt off the side brush.
•
Remove lint, hair and other dirt from the drive axle.
•
Remove the brush cover to do so if needed (see Section “4.3 Cleaning the
round brush” on page 40).
•
To reattach the side brush, align the centre of the side brush with the mount-
ing point and push the side brush onto the drive axle.
11
12
13
Figure 4.5 Reinstalling the dust container
and fi lter in the dust compart-
ment
1
2
Figure 4.6 Pulling off the side brush
Содержание KOBOLD VR200
