Vonsch Quatrofrem Series, Конфигурация и диагностика

Страница: 54 / 180

UNIFREM v.3.41x
10 May 2017 Page 54 from 180
7.4.6 DISCRETE SETPOINTS
Group of parameters number [60]
Discrete setpoint value setting.
Discrete setpoint values can serve as the setpoint values signals for any quantity as exact, predefined
values.
MENU \ SETTINGS \ COMMANDS \ DISCRETE SETPOINTS
Name [ID] Description Def.
Discrete
setpoint switch
[576]
Discrete setpoint value switch type setting. Single
Combined
Only the first 3 bits of the DS switch are used. Output value corresponds to the binary
combination of these bits. If no bits are active, the Value Value 0 [220] (page 54) is on the
output. If only 1 bit is active, the Value Value 1 [239] (page 54) is on the output and so on.
Single
Every single bit of the DS switch stands for one discrete setpoint value (1.bit stands for the
1. value and so on.). If there are more DS switches active, value with the higher switching
bit is on the output. If no DS switch is active, discrete value 0 is on the output.
DISCRETE VALUES
Group of parameters number [84]
Single discrete value setting. It is possible to set the value only when the signal Discrete setpoint [10] (page
15) is connected. Physical dimension and range of values are inherited according to the target where the
signal is connected.
Warning! When configuring speed control of a crane drive, it might be necessary to set Value 0 [220] (page
54) a Value 1 [239] (page 54) to the same value.
MENU \ SETTINGS \ COMMANDS \ DISCRETE SETPOINTS \ DISCRETE VALUES
Name [ID] Description Def.
Value 0 [220] Zero value of the discrete setpoint value. This value applies, when no switch bit is set. -
- ÷ -
Value 1 [239] First value of the discrete setpoint value. -
- ÷ -
Value 2 [245] Second value of the discrete setpoint value. -
- ÷ -
Value 3 [293] Third value of the discrete setpoint value. -
- ÷ -
Value 4 [475] Fourth value of the discrete setpoint value. -
- ÷ -
Value 5 [299] Fifth value of the discrete setpoint value. -
- ÷ -
Value 6 [550] Sixth value of the discrete setpoint value. -
- ÷ -
Value 7 [551] Seventh value of the discrete setpoint value. -
- ÷ -
DS SWITCH
Group of parameters number [100]
Binary switch setting for switching the discrete setpoint values.
MENU \ SETTINGS \ COMMANDS \ DISCRETE SETPOINTS \ DS SWITCH
Name [ID] Description Def.
Bit1 DS
source [552]
Bit source setting for the binary switch for the discrete setpoint values. Its function
depends on the Discrete setpoint switch [576] (page 54) parameter setting.
None
Look choises of parameter's Quick stop source. [986] (page 49)
Bit2 DS
source [555]
See Bit1 DS source [552] (page 54). None