Vonsch Quatrofrem Series, Конфигурация и диагностика

Страница: 41 / 180

UNIFREM v.3.41x
10 May 2017 Page 41 from 180
7.1.7 Control methods, parameter identification, dynamics of the drive
Step 6 – Control and regulation
V/f ident. Standsti ll
(1500)
Identificat ion
successful?
Step 7 – Basic parameters
YES NO
Done
Min. frequency(110)
Max. frequency (111)
Ramp-up 1 time (116)
Ramp-down 1 time (119)
Do you want scalar (V/f) or v ector
control met hod?
V/f
Step 8 – Finish
Vector
Is it a non-recommended
combination?
Thi s setting i s not
recommended! Do you want to
continue anyway?
YES
NO
Do you want to perform a
short offline identification of
mot or parameters?
Offline ident ification (992)
Offline ident ification successful.
Offline ident ification
fail ed.
NO
YES
YES
Do you want to perform a
mot or parameter
identificati on?
YES
NO
Do you want to perform an
identification of motor parameters
which rotat es the motor?
Ident. Lm (short) (1498)
Identificat ion
successful?
Mag. curve identificati on failed.
Please, follow the documentation.
Mag. curve identificati on was succesful.
Magnet ic Flux set poi nt (452)
SC Damping (449)
SC Dynamics 1(457)
SC Dynamics 2 (1128)
Dynamics break (1129)
Copy Max. freq (111) to Ramp-up break (117)
Copy Max. freq. (111) to Ramp-down break (121)
Max. mot. current (5)
Max. regen. current (549)
Max. voltage (495)
Switching frequency (6)
NO
Part 2
YES
Identificat ion successful.
Possible fine tuning of following paramet ers :
V/f type (347)
Starting voltage (90)
End v oltage (94)
Frequency shi ft (98)
V/f exponent (91)
STC Current (163)
YES
Waiting for st art command
Identificat ion was ski pped.
You can set t he motor
parameters or perform the
identificati on l ater.
Identificat ion was ski pped.
You can set t he motor
parameters or perform the
identificati on l ater.
NO
Wizard part 3, Control and identification