Vonsch Quatrofrem Series, Конфигурация и диагностика

Страница: 159 / 180

UNIFREM v.3.41x
10 May 2017 Page 159 from 180
For example:
- V/f curve parameter change when changing the motor rotation direction.
- converter control sources change from the binary input (switching locally/remotely).
- controller parameter adaptivity according to the regulated frequency range.
- and many more.
Parameter set switch conditions are configured in these converter parameters:
Parameter ID:
206
SETTINGS – > PAR. SETS
Switch set of parameters example configuration:
Parameter name ID Description
Set switching 657 Setting the way of switching between the sets.
(
Combined, Single, Parameter )
Active set switching setting example
Possibility to switch
the active set: SETTINGS – > PAR. SETS – > Set switching [657] – > Parameter
Option of the active set setting:
Active set [205]
– > option choice Set 1, Set 2, Set 3, Set 4
Bit1 set source
Bit2 set source
Bit3 set source 641
6426
43
Setting the bits of set switch. Its function depends on the parameter
Set switching [657] setting.
1.way
Set switching [657] - Combined -
Only the first 2 bits of the binary
switch are used. Output set corresponds to the binary combination of
these bits. If no bits are active, the 1
st
set is active. If only 1 bit is active,
the 2
nd
set is active, and so on.
SETTINGS
– > PAR. SETS – > SET SWITCH
Setting possibility: Bit1 set source and Bit2 set source
Binary switch setting example
2.way
Set switching [657]
– Single - Every single bit of the binary switch
represents one set (bit 1 represents set 2). If more switches are active,
the set with the higher sequence number is active. If no binary switch is
active, the 1st set is active.
SETTINGS
– > PAR. SETS – > SET SWITCH
Setting possibility: Bit1 set source, Bit2 set source, Bit3 set
source
Binary switch setting example