Volvo Ingersoll Rand SD-116 TF Series, Руководство оператора

Страница: 72 / 300

SECTION 4 OPERATING INSTRUCTIONS
4-8 SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX
Figure 4-10
8. Press the horn button (8, Figure 4-10) to verify the horn is operational.
9. To confirm that engine will only start with the propulsion control in the STOP
position, move propulsion control lever (19, Figure 4-8) in either
direction away from the STOP position.
10. Make sure no personnel are close to the machine, with the brake applied, turn
the ignition key (12, Figure 4-10) to the Start position. The engine should
not start, verifying that the machine will not start with the propulsion control
lever in a position other than the STOP position.
11. Return ignition switch (12, Figure 4-10) to the STOP position.
12. Place the propulsion control lever (19, Figure 4-8) in the STOP
(center) position.
PROPELLING MACHINE AND OTHER CHECKS/VERIFICATIONS WHILE
ENGINE IS RUNNING.
NOTE: If any controls or devices do not function correctly, do not operate the
machine until the condition(s) is corrected.
1. Press and hold release pushbutton (17, Figure 4-11) and slowly move
propulsion control (19) in desired direction and safe speed of travel as
determined by the conditions. The further the control is moved from the STOP
position the greater the speed in that direction.