Volvo Ingersoll Rand SD-116 TF Series, Руководство оператора

Страница: 35 / 300

SAFETY SECTION 1
SD-116F/DX/122D/F/DX/160F/DX/190DX/200F/DX 1-11
CUT off the power supply to parts of the machine on which inspection, maintenance and repair
work is to be carried out.
CHECK the de-energized parts for the presence of power and ground or short circuit them in
addition to insulating adjacent live parts and elements before starting work.
INSPECT the electrical equipment of machines at regular intervals. Defects such as loose
connections or scorched cables must be rectified immediately.
DO NOT weld, flame cut or peform any grinding operations on the machine unless expressly
authorized as there may be a risk of explosion and fire.
CLEAN the machine and its surroundings from dust and other flammable substances and
make sure that the premises are adequately ventilated (risk of explosion) before beginning
welding, flame cutting and grinding operations.
INSPECT hydraulic hoses at regular intervals and immediately replace if they show signs of
chafing, cracking, brittleness, deformation, blistering, leakage, fitting separation, corrosion or
other damage which may affect their function or strength.
DO NOT work on hydraulic lines while the engine is running and the system is under pressure.
The hydraulic fluid remains pressurized long after the engine has stopped.
DO NOT work on any hydraulic hose or fitting until the pressure has been properly relieved.
WAIT for fluid to cool down before disconnecting. Hot hydraulic fluid will cause severe burns.
NEVER use your hands to check for leaks when inspecting an hydraulic system. Use a piece
of cardboard and always wear gloves and safety glasses.
GET immediate attention if fluid has been injected under your skin. Fluid penetration from a
pin hole leak can cause severe injury or death.
ENSURE hydraulic lines are laid and fitted properly. Ensure that no connections are
interchanged. The fittings, lengths and quality of the hoses must comply with the technical
requirements.
OBSERVE the product related safety regulations when handling oil, grease and other
chemical substances. Be careful when handling hot consumables (risk of burning or scalding).
TRANSPORTING, TOWING AND ROADING
USE only appropriate means of transport and lifting gear of adequate capacity.
ENTRUST to experienced persons only the fastening of loads and the instructing of crane
operators. The personnel giving the instructions must be within sight or sound of the operator.
DO NOT attempt to load the compactor on the transporters without knowledge and experience
with the operation of the compactor.
ALWAYS use a ramp when loading the compactor on the transporter. Be sure ramps are of
adequate strength, low angle, and proper height and width.
USE proper chock blocks in front and rear of the wheels of the transporter when loading the
compactor.
ENSURE the trailer is on level ground and approach the transporter loading ramps squarely
to make sure the compactor does not drop off the side of the ramp.