Vitrolux H
V2
Operation
Stand 5/12
Page 38 of 57
4.1 Power-on routine
Preparations
1. Check that the power supply is connected correctly.
2. Check that the Emergency Stop button is not locked.
3. Check that the doors are closed (if any).
Power-on routine
1. Switch the main switch on the control module box on the side of the system in the
"ON" position.
2. Switch on the PC.
(The switch is located right on top of the console housing.)
3. Log in via the PC keyboard.
Note
It is possible that a password has been assigned for the login procedure.
Enter the correct password and confirm with OK.
4. Switch on the green power switch on the front of the PC console.
The red indicator "Fault" goes off then after a few seconds.
5. Start the program "VitroMark"
The laser system is now switched on and ready to start production.
4.2 Load / Engrave
1. Press the "cover" button (a quiet "click" indicates that the locking of the door has
solved) and open the door when holding down the "cover"-button.
2. Position objects to engrave on the table.
Please note the maximum possible engraving area is 400x300x95mm.
3. Close the door and start the laser process on the software "VitroMark".
4. Wait for the end of the laser process (the "cover" button lights up again), then open
the door as described in 1., remove the finished products and continue until all the
objects are completed then as described in 2..
Caution!
During the laser process, the door can not be opened - the key of "Cover" is
locked during this time, to avoid accidentally stopped engraving. For
deliberate interruptions of the whole process in case of an emergency,
please use the "Emergency stop" button
.
