Vitrolux H
V2
Safety
Stand 5/12
Page 11 of 57
1.3 Accident prevention regulations
1.3.1 General information
Before starting the equipment up for the first time following assembly (new installation or
assembly after transport), a safety check must be made. All the load-bearing and machine
parts must be checked that they are in perfect condition.
Check that the laser system is operationally safe before starting up each day! Apart from the
information in the operating manual, the generally applicable and any local safety and
accident prevention regulations must also be observed.
The warning and information labels attached provide important information on safe operation.
Observe this information in the interest of third-parties as well as your own.
Any faults which occur that affect safety must be cleared immediately.
Damaged parts must be replaced immediately. The laser system may not be operated again
until the fault has been cleared
All mentioned directions are viewed from the operating side.
.
Direction of rotation is defined as follows:
Turn right = clockwise
Turn left = anticlockwise
The turning of screws, nuts, etc., is always viewed from the operating side
1.3.2 Laser system
The laser system can be delivered as Laser Class 1 (with cover and doors) or as Laser Class
4 (as shown on front page of this manual).
The system
complies to
Laser Class 1 under normal working conditions with cover and doors
fully closed.
The laser system may only be operated under the following conditions in Normal mode:
The housind and doors are fully closed (Laser Class 1)
All persons located in the same room as the system wear safety-glasses (Laser Class 4)
The laser head, scan head and laser beam path to it’s intended outlet at the lens are fully
closed
The operating personnel has been instructed and has read and understood the operating
manual
The fiber optics are not damaged.
Warning
The laser may only set to production mode when the protective guards and cover
flaps are closed, the laser head and scan head are closed and the laser beam
path is covered. The optical waveguide must not be damaged. Risk of accident.
Warning
If the beam guide is not mounted, the laser beam escapes at the side of the laser
head.
Risk of accident.
