Viper 320HV, Руководство по установке

Страница: 18 / 34

1 18 8
© 2004 Directed Electronics, Inc. Vista, CA
The system is most commonly found in Ford, Mazda, Chrysler and GM vehicles. The door lock switch or door key
cylinder may contain either one or two resistors.
SSIIN NG GLLEE--R REESSIISSTTO OR R TTY YP PEE:: If one resistor is used in the door lock switch/key cylinder, the wire will pulse ground in
one direction and resistance to ground when operated in the opposite direction.
TTW WO O--R REESSIISSTTO OR R TTY YP PEE:: If two resistors are used in the factory door lock switch/key cylinder, the door lock
switch/key cylinder will read resistance to ground in both directions.
D DEETTEER RM MIIN NIIN NG G TTH HEE P PR RO OP PEER R R REESSIISSTTO OR R V VA ALLU UEESS:: To determine the resistor values, the door lock switch/key cylinder
must be isolated from the factory door lock system. For testing, use a calibrated digital multimeter that is set to ohms.
IIM MP PO OR RTTA AN NTT:: To ensure an accurate resistance reading, do not touch the resistor or leads during
testing.
1. Cut the output wire from the door lock switch/key cylinder in half.
2. Test with the meter from the switch side of the cut door lock switch/key cylinder wire to a reliable ground
source. Some good ground references are the ground input source to the door lock switch/key cylinder or the
battery ground.
3. Operate the door lock switch/key cylinder in both directions to determine the resistor values. If the multi-
meter displays zero resistance in one direction, no resistor is needed for that direction.
4. Once the resistor value(s) is determined, refer to the wiring diagram for proper wiring.
ttyyppee H H:: nneeggaattiivvee ((--)) m muullttiipplleexx