Viper 320HV, Руководство по установке

Страница: 7 / 34

© 2004 Directed Electronics, Inc. Vista, CA
7 7
Before connecting this wire, remove the supplied fuse. Connect to the positive battery terminal or the constant
12V supply to the ignition switch.
N NO OTTEE:: Always use a fuse within 12 inches of the point you obtain (+)12V power. Do not use the
15A fuse in the harness for this purpose. This fuse protects the module itself.
When the system receives the code controlling Channel 2, for longer than 1.5 seconds, the red/white wire will
supply an output as long as the transmission continues. This is often used to operate a trunk/hatch release or
other relay-driven function.
IIM MP PO OR RTTA AN NTT!! Never use this wire to drive anything but a relay or a low-current input! The tran-
sistorized output can only supply 200 mA of current. Connecting directly to a solenoid, motor,
or other high-current device will cause it to fail.
H H1 1//1 12 2 R REED D//W WH HIITTEE cch haan nn neell 2 2,, ((--)) 2 20 00 0m mA A o ou uttp pu utt
H H1 1//1 11 1 R REED D ((+ +))1 12 2V V cco on nssttaan ntt p po ow weerr iin np pu utt