Viper 320HV, Руководство по установке

Страница: 23 / 34

© 2004 Directed Electronics, Inc. Vista, CA
2 23 3
pplluugg--iinn LLEEDD aanndd vvaalleett//pprrooggrraam m sswwiittcchh
The LED and the Valet/Program switch both plug into the control module. The LED system status indicator plugs
into the white two-pin port, while the Valet ® /Program switch should be plugged into the blue two-pin port. The
LED and Valet ® /Program switch each fit into 9 /
32
-inch holes.
LLEED D SSyysstteem m SSttaattu uss IIn nd diiccaatto orr V Vaalleett ® ® //P Prro og grraam m SSw wiittcch h
iinntteerrnnaall pprrooggrraam mm miinngg jjuum mppeerr
This jumper is used to determine the light flash output. In the (+) position, the on-board relay is enabled and
the unit will output (+)12V on the H1/2 WHITE wire. In the (-) position, the on-board relay is disabled. The H1/2
WHITE wire will supply a (-) 200 mA output suitable for driving factory parking light relays. To access the jumper,
open the control module.
lliigghhtt ffllaasshh jjuum mppeerr
NOTE: JUMPERS ARE
INSIDE THE CASE
DIA-41