Viper 320HV, Руководство по установке

Страница: 31 / 34

© 2004 Directed Electronics, Inc. Vista, CA
3 31 1
1 10 0 CCo om mffo orrtt ccllo ossu urree ffeeaattu urree:: This feature is designed to integrate with vehicles that can close the power windows
and sunroof by holding the key in the driver door lock position, and will operate on both single input systems
and two pulses input dead bolt systems.
If programmed on the door lock output will activate the Comfort Close output for 20 seconds. This output will
begin 200mS after the final door lock output has completed regardless of the door lock programming.
If while the 20 second timer is active and closing the windows the user disarms the unit, the Comfort Close
output will immediately cease before the doors unlock.
The alarm system will not monitor the zone inputs for Bypass Notification, Warn away or Full trigger inputs until
after the 20 second timer has completed to avoid any false triggering of the system while the window are in
motion.
nnuuiissaannccee pprreevveennttiioonn cciirrccuuiittrryy ™ ™
NPC™ requires that you change the way you test the system, as NPC™ will bypass an input zone for 60 minutes.
If the system “sees” the same zone trigger three times AND the triggers are spaced less than an hour apart, the
system will bypass that input zone for 60 minutes. If that zone does not attempt to trigger the system during
the 60-minute bypass period, the zone’s monitoring will begin again at the end of the hour. If it does attempt
to trigger while bypassed, the 60-minute bypass starts over again.
Disarming and rearming the system does not reset NPC™. The only way to reset NPC™ is for the 60 minutes to
pass, without a trigger, or for the ignition to be turned on. This allows the system to be repeatedly triggered,
disarmed and rearmed, and still allow NPC™ to bypass a faulty zone.
When disarming the system, 5 chirps indicate NPC is activated. The LED will report the zone that has been
bypassed. (See Table of Zones section of this guide.)