Vintage Air 1967-68 CAMARO w/o Factory Air Gen IV, Руководство пользователя

Страница: 9 / 18

9
www.vintageair.com
905168 REV G 4/13/15, PG 9 OF 17
Install the cable converter assembly onto the Cold/Hot lever.
Install the cable converter push rod onto the OEM cable mounting stud on the lever.
Secure the cable converter assembly onto the OEM control panel using the OEM screw in the OEM cable clamp
mounting location (See Figure 9, below).
Since the cable converter assembly can slide back and forth in the clamp before the screw is tightened, position
the cable converter assembly such that the flat part of the rod is as close to flush as possible with the end of
the housing at the lever’s innermost position.
Secure the cable converter lever push rod onto the OEM cable mounting stud using a 3/16” push-on ring as
shown in Figure 9, below.
Locate the control panel wiring harness, and plug the corresponding wire into the correct cable converter
assembly as shown in Figure 10, below.
Cold/Hot Cable Converter Assembly
& Control Harness Installation
1.
2.
3.
4.
5.
6.
Bottom Side of
Control Panel
Cold/Hot
Cable Converter
Assembly
Cold/Hot Cable Converter
Assembly
Red
White/Red
White
Figure 9
Figure 10