Vintage Air 1967-68 CAMARO w/o Factory Air Gen IV, Руководство пользователя

Страница: 12 / 18

12
www.vintageair.com
905168 REV G 4/13/15, PG 12 OF 17
Final Steps
Using the supplied tie wraps, tie the wires to the control panel. Confirm that wires are secured and do not
interfere with lever operation or cable converter assembly.
Install control panel into dash using OEM screws. To ease installation, rotate control panel slightly and pass the
cable converter assemblies through the dash opening first. As the cable converter assemblies pass through the
dash opening, rotate the control panel back the opposite direction to fit control panel into the dash. NOTE:
Make sure cable converter assemblies clear the duct hose behind the left side of the dash opening.
Do not force the control panel into the dash. Forcing the control panel into the dash will damage the
cable converter assemblies and/or duct hose.
Plug the wiring harnesses into the ECU module on the sub case.
Wire according to the wiring diagram on Page 16.
Calibration procedure and operation instructions:
A. Calibrating the control panel will set the range of travel for the cable converters connected to the OEM
control panel levers. Performing this procedure will set the limits of the cable converters at their highest
and lowest points.
B. Locate the gray wire with an unused connector in the wiring harness near the two cable harness relays.
This wire is labeled PROGRAM on the wiring diagram.
C. It will be necessary to ground the gray wire for approximately five seconds while moving the controls, so
it is sometimes helpful to attach one end of the white jumper to the vehicle’s ground (for example, the
chassis) and have the other end ready to connect to the gray PROGRAM wire when the procedure requires
it.
D. To calibrate the control panel, follow the calibration procedures on Pages 14 & 15.
1.
2.
3.
4.
5.
NOTE: Tie the unused wire to the
control panel approximately as
shown. Ensure that the wire does
not interfere with levers or cable
converter assemblies.
Unused Red,
White/Blue,
White Wire Tie Wrap
Plug From Control
Wiring Harness
232002-VUA
Plug
From Wiring
Harness
232001-VUR