Vintage Air 1967-68 CAMARO w/o Factory Air Gen IV, Руководство пользователя

Страница: 7 / 18

7
www.vintageair.com
905168 REV G 4/13/15, PG 7 OF 17
Turn control panel over, with bottom side facing up.
Install the cable converter assembly onto the Dash/Floor/Defrost lever (See Figure 6, below).
Install the cable converter push rod onto the OEM cable mounting stud on the lever.
Secure the cable converter assembly onto the OEM control panel using the OEM screw in the OEM cable clamp
mounting location (See Figure 6, below).
Since the cable converter assembly can slide back and forth in the clamp before the screw is tightened, position
the cable converter assembly such that the flat part of the rod is as close to flush as possible with the end of
the housing at the lever’s innermost position (See Figure 6, below).
Secure the cable converter lever push rod onto the OEM cable mounting stud using a 3/16” push-on ring as
shown in Figure 6, below.
Dash/Floor/Defrost Cable Converter
Assembly Installation
1.
2.
3.
4.
5.
6.
3/16” Push-on
Ring
OEM Cable
Mounting Stud
OEM Cable
Mounting Location
End of Rod
Flat Section
End of
Housing
NOTE: Do not allow rod to
separate housing when rod
is in innermost position.
Rod Shown
in Approximately
Innermost
Position
Flush
1/8” Max
Bottom Side of
Control Panel
OEM Screw
Dash/Floor/Defrost
Cable Converter
Assembly
Figure 6