4
www.vintageair.com
905168 REV G 4/13/15, PG 4 OF 17
Remove (4) OEM screws from the dash bezel,
under the dash (retain) (See Figure 1, below).
Remove the OEM control panel from the dash (retain).
Disconnect the cables and wires from the back side
of the OEM controls (discard).
Remove the (2) screws securing the OEM fan switch to
the top of the control panel. Remove the fan switch
from the control panel (discard).
Removing OEM Control Panel
1.
2.
3.
4.
Perform the Following:
Control
Panel
ON
COLD
DASH
FLR
DEF
HOT
OFF
Placard Installation
NOTE: The OEM control panel placard can be used with this system. However, the bottom of the placard
will not depict actual mode settings. The actual mode settings are shown on the replacement placard
mode label that comes with this kit. To use the replacement placard mode label, you must modify parts
of the control panel assembly as described below. We leave it up to you, the customer, to decide if you
would like to use the OEM placard or the replacement placard mode label.
To Use the Replacement Placard Mode Label:
Remove the (3) lever knobs (See Figure 2, below).
Remove the (4) control panel face plate mounting rivets. Drill out the rivets using a 9/64” drill bit (See
Figure 2, below).
Remove the OEM control panel face plate, placard and OEM backing plate from the control panel. Orient the
OEM backing plate as shown in Figure 2, below. Using a suitable method, cut along the inside edge of the
flange as shown.
1.
2.
3.
Remove (4)
OEM Screws
Control Panel
Face Plate
(2) Rivets
(2) Rivets
Cut Along
Inside Edge of
Flange
After Edge of Backing
Plate is Removed
(3) Knobs
Figure 1
Figure 2
Содержание 1967-68 CAMARO w/o Factory Air Gen IV
Страница 17: ......