Vintage Air 1967-68 CAMARO w/o Factory Air Gen IV, Руководство пользователя

Страница: 8 / 18

8
www.vintageair.com
905168 REV G 4/13/15, PG 8 OF 17
Remove OEM fan switch actuator stud (See Figure 7 and photos, below). NOTE: Fan switch actuator stud
removal is required to allow clearance for duct hoses. Failure to remove the stud will result in a
punctured duct hose.
Locate the control panel wiring harness, and plug the corresponding wire into the correct cable converter
assembly as shown in Figure 7, below.
Once the wires are correctly plugged into the cable converter assembly, secure the wires to the cable converter
assembly using the supplied tie wraps. The tie wrap must be located between the end of the wire jacket and
the step in the cable converter housing, forcing a bend in each wire as it passes over the step in the cable
converter housing. The head of the tie wrap must fall on the edge of the housing to remain tight. Ensure that
the tie wraps are tight enough that the wires cannot move (See Figure 8, below).
Dash/Floor/Defrost
Control Harness
1.
2.
3.
OEM Cable
Mounting Stud
Bottom Side of
Control Panel
Dash/Floor/Defrost
Cable Converter
Assembly
Force Bend
in Wires
Over Step
Step in
Cable Converter
Housing
Tie Wrap
Tie Wrap
Wire
Jacket
Wire
Jacket
Cable Converter
Assembly
Cable Converter
Clamp
Dash/Floor/Defrost
Cable Converter
Assembly
Red
White/Yellow
White
OEM Fan Switch
Actuator Stud
Before Stud Removal
After Stud Removal
Figure 7
Figure 8