Vintage Air 1967-68 CAMARO w/o Factory Air Gen IV, Руководство пользователя

Страница: 10 / 18

10
www.vintageair.com
905168 REV G 4/13/15, PG 10 OF 17
Install the cable converter assembly onto the Off/Hi lever.
Install the cable converter push rod onto the OEM cable mounting stud on the lever.
Secure the cable converter assembly onto the OEM control panel using the OEM screw in the OEM cable clamp
mounting location (See Figure 12, below).
Since the cable converter assembly can slide back and forth in the clamp before the screw is tightened, position
the cable converter assembly such that the flat part of the rod is as close to flush as possible with the end of
the housing at the lever’s innermost position.
Secure the cable converter lever push rod onto the OEM cable mounting stud using a 3/16” push-on ring as
shown in Figure 12, below.
Off/Hi Cable Converter Assembly
Installation
1.
2.
3.
4.
5.
Cold/Hot Control Harness (Cont.)
Once the wires are correctly plugged into the cable converter assembly, secure the wires to the cable converter
assembly using the supplied tie wraps. The tie wrap must be located between the end of the wire jacket and
the step in the cable converter housing, forcing a bend in each wire as it passes over the step in the cable
converter housing. The head of the tie wrap must fall on the edge of the housing to remain tight. Ensure that
the tie wraps are tight enough that the wires cannot move (See Figure 11, below).
1.
Force Bend
in Wires
Over Step
Step in
Cable Converter
Housing
Cable Converter
Clamp
Cable Converter
Assembly
Tie Wrap
Tie Wrap
Wire
Jacket
Wire
Jacket
Figure 11
Figure 12