Vintage Air 1967-68 CAMARO w/o Factory Air Gen IV, Руководство пользователя

Страница: 11 / 18

11
www.vintageair.com
905168 REV G 4/13/15, PG 11 OF 17
Locate the control panel wiring harness, and plug the corresponding wire into the correct cable converter
assembly (See Figure 13, below).
Once the wires are correctly plugged into the cable converter assembly, secure the wires to the cable converter
assembly using the supplied tie wraps. The tie wrap must be located between the end of the wire jacket and
the step in the cable converter housing, forcing a bend in each wire as it passes over the step in the cable
converter housing. The head of the tie wrap must fall on the edge of the housing to remain tight. Ensure that
the tie wraps are tight enough that the wires cannot move (See Figure 14, below).
Off/Hi Control Harness
1.
2.
Off/Hi
Cable Converter
Assembly
Wire
Jacket
Wire
Jacket
Tie Wrap
Force Bend
in Wires
Over Step
Step in
Cable Converter
Housing
Cable Converter
Assembly
Cable Converter
Clamp
Tie Wrap
Off/Hi Cable Converter
Assembly
Red
White
White/Green
Figure 13
Figure 14