Disassembly
36
©2010 Viking Preferred Service
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Griddle Temperature Sensor (RTD) Removal
(VGSC536-4G, VGSC548-6G, & VGSC548-4GQ)
Condition Requirements:
Griddle Plate and Drip Pan Removed
1. Remove two screws that attach the sensor to the
range.
2. Pull the sensor until the sensor connector is visible.
3. Disconnect sensor connector.
4. Reverse procedure for installation.
Griddle Burner Removal
(VGSC536-4G, VGSC548-6G, & VGSC548-4GQ)
Condition Requirements:
Griddle Plate and Drip Pan Removed
1. Remove screws, griddle burner bracket, and griddle
burner from range.
2. Remove screw and griddle burner bracket from
griddle burner.
3. Reverse procedure for installation.
Griddle Burner Igniter Removal
(VGSC536-4G, VGSC548-6G, & VGSC548-4GQ)
Condition Requirements:
Griddle Plate and Drip Pan Removed
1. Remove two screws and igniter from range.
2. Disconnect wire from igniter.
3. Reverse procedure for installation.
Island Trim Removal
Condition Requirements:
Rear of Range Accessed
1. Remove four screws and island trim from range.
2. Reverse procedure for installation.
Backguard Assembly Removal
Condition Requirements:
Rear of Range Accessed
1. Remove four screws and backguard assembly from
range.
2 Reverse procedure for installation.
