Disassembly
40
©2010 Viking Preferred Service
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Side Trim and Side Panel Removal
Condition Requirements:
Control Panel Assembly Removed
Island Trim or Backguard Assembly Removed
1. Remove two screws and lift kick plate from keyhole
screws.
2. Remove two screws and side trim from range.
3. Remove screw and side trim support from range.
4. Remove four screws and side panel from range.
5. Reverse procedure for installation.
Hinge Receiver Removal (Left Side Shown)
Condition Requirements:
Door Assembly Removed
Side Panel Removed
1. Disconnect connector from bracket.
2. Remove screws, trim, and interior side panel from
range.
3. Pull back insulation to access hinge receiver.
4. Remove two screws, hinge trim and hinge receiver
from range.
5. Reverse procedure for installation.
