Disassembly
©2010 Viking Preferred Service
33
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Oven Light Bulb Removal
Condition Requirements:
Door Lowered
DO NOT touch bulb with bare hands. Clean off any
signs of oil from the bulb and handle with a soft cloth.
1. Unsnap glass light cover using a screwdriver in the
access groove.
2. Firmly grasp light bulb and pull out.
3. Replace with halogen bulb using volt and wattage
requirements listed on glass cover.
4. Replace the light cover by snapping glass cover onto
metal box.
1
2
3
4
Oven Light Switch Removal
Condition Requirements:
Control Components Accessed
1. Mark and disconnect two connectors from light
switch.
2. Press tabs on both ends of the switch and push
switch through control panel.
3. Reverse procedure for installation.
Side Light Housing Removal
Condition Requirements:
Door Assembly Removed
Control Components Accessed
1. Disconnect connector for side light housing.
2. Remove screw and side light housing from oven liner.
3. Reverse procedure for installation.
Indicator Light Removal
Condition Requirements:
Control Components Accessed
1. Hold the red lens and slide off the indicator light. The
indicator light will only slide in one direction.
2. Disconnect two connectors from the indicator light.
3. Reverse procedure for installation.
