Viking VFR400, Руководство пользователя

Страница: 24 / 99

24
VFR-400 • 5403548 • REV W • 8/17
Date/Time
SELECT To change the time, press the SELECT button.
FUNCTION
To exit to the next function, press the FUNCTION button.
If the SELECT button is pushed, the date and time will appear in the display window:
S E T T I M E ?
0 1 / 0 5 / 2 0 0 7
}
}
ZONE 1
ZONE 2
ZONE 3
ZONE 4
OUTPUT 1
OUTPUT 2
OUTPUT 3
OUTPUT 4
POWER ON
POWER TBL
SYSTEM TBL
SUP /ABORT TBL
EARTH
FAULT
RUN
(PROGRAM)
SUPERVISORY 1
SUPERVISORY 2
COMMON ALARM
SIGNAL SILENCE
STEADY: DISCHARGE
FLASHING:
PRE-DISCHARGE
VIEWING ANGLE
(SET)
(SELECT)
(FUNCTION)
SIGNAL SILENCE
SYSTEM RESET
DWG# 3550-18VKG
ALM SIGNAL
ACTIVATION HOLD
FOR 2 SECONDS
RELEASING
SERVICE SIGNAL
SILENCE HOLD
FOR 2 SECONDS
LAMP
TEST
SCROLL-DOWN
TBL/SUP
ACKNOWLEDGE
SCROLL-UP
TBL/SUP
ACKNOWLEDGE
PROGRAMMING MODE INSTRUCTIONS
To use the Programming Mode push the program switch down
(see drawing below).
PANEL VISUAL DISPLAY
As a general rule, the following applies on the Programming
Mode buttons:
The SET button sets the message on the display into the
memory.
The SELECT button scrolls through the selections available
for the function displayed.
The FUNCTION button allows the user to skip the function
without changing the program.
To program, push the Program Switch down.
There is no capability to back up screens in the program mode. If a mistake was made during programming, move the program
switch back up, then move it down and start from the beginning.
To exit the program mode at any time, move the Program Switch up.
When the programming switch is down (see Panel Visual Display) the following will appear in the display window:
History
To examine the HISTORY press the top button, the display window will show the time and date of the last event or action. To skip
to the next function or to exit history, press the FUNCTION button.
SET Press the SET button to discover the time and date of the last event or action and to scroll forward.
SELECT To scroll back, press the SELECT button.
FUNCTION
To exit or skip HISTORY, press the FUNCTION button.
L O O K A T
H I S T O R Y ?