Viessmann F11T, Инструкции по установке и обслуживанию для подрядчиков

Страница: 55 / 168

55
Commissioning steps
Inspection steps
Maintenance steps Page
• • •
1. Removing the front panels ................................................................................................ 57
•
2. Checking the power supply
•
3. Filling the trap on the gas condensing module with water ............................................ 58
•
4. Filling the fuel cell module trap ........................................................................................ 59
•
5. Overview of water circuits ................................................................................................. 60
•
6. Filling the DHW cylinder .................................................................................................... 61
• • •
7. Measuring static pressure ................................................................................................. 62
•
8. Filling gas condensing module and heating circuits ...................................................... 62
•
9. Commissioning the system ............................................................................................... 65
•
10. Filling system separation circuit fuel cell module .......................................................... 68
• • •
11. Checking all connections on the heating water and DHW sides for leaks
•
12. Setting max. heating output (gas condensing module) ................................................. 69
•
13. Naming the heating circuits .............................................................................................. 69
•
14. Entering heating contractor contact details .................................................................... 69
• • •
15. Measuring connection pressure (flow pressure) ........................................................... 69
• • •
16. Function sequence and possible faults (gas condensing module) .............................. 71
•
17. Fuel cell module commissioning ...................................................................................... 72
•
18. Starting maintenance mode .............................................................................................. 72
•
19. Converting the gas type on the fuel cell module ............................................................ 73
•
20. Adjusting parameters for the mains monitor (ENS) (country setting) .......................... 74
• •
21. Filling with distilled water and starting the system ........................................................ 74
• •
22. Terminating maintenance mode and activating energy manager ................................. 76
• •
23. Tightness test on balanced flue system (annular gap check) ....................................... 76
•
24. Burner removal (gas condensing module) ...................................................................... 77
• •
25. Checking the burner gasket and burner gauze assembly (gas condensing module) . 78
•
26. Checking the back draught safety device ........................................................................ 79
•
27. Checking and adjusting ignition and ionisation electrode (gas condensing module) 79
•
28. Cleaning heating surfaces (gas condensing module) .................................................... 80
• •
29. Checking condensate drain and cleaning the trap (gas condensing module) ............. 80
• •
30. Fitting the burner (gas condensing module) ................................................................... 82
•
31. Checking the neutralising system (if installed)
•
32. 5-yearly maintenance of fuel cell module ........................................................................ 82
•
33. 10-yearly maintenance of fuel cell module ...................................................................... 84
•
34. Filling and venting the heating system after maintenance work ................................... 84
•
35. Checking the diaphragm expansion vessel and pressure in the system separation
circuit ................................................................................................................................... 85
• •
36. Checking the external diaphragm expansion vessel (heating circuits) and system
pressure .............................................................................................................................. 85
• • •
37. Checking the safety valve function
Commissioning, inspection, maintenance
Steps - commissioning, inspection and maintenance
5853335