RECEIVING TOOL
VE416FS tools are packed individually in sturdy
containers, designed for use in reshipping tools
upon completion of the rental contract, when
applicable .
NOTE:
Be sure to save original shipping
container for return shipment of rental tools .
Upon receipt of tool, make sure all necessary
parts are included . If any parts are missing,
notify your Victaulic distributor or Victaulic
representative .
VE416FS CONTAINER CONTENTS
VE416FS SHOWN
VE416FS pallet should contain:
A.
One small box which contains:
1.
2”-31/2” roll set assembly .
B.
One large box which contains:
1.
Tool head/mounting stand assembly .
2.
Two (2) telescoping legs .
3.
Pump/pump support assembly .
4.
Pump handle .
5.
Roll storage chest with additional roll
sizes .
6.
Two (2) Tool Operating and Maintenance
Instruction Manuals
VE416FSD palletized box should contain:
1.
VE416FSD tool includes: Tool head/stabilizer,
mounting table/gear motor, hand pump, pump
support, four (4) legs and foot switch with cord .
2.
Box containing 2 - 31/2” roll set assembly .
3.
Roll storage chest with additional roll sizes .
4.
Pump handle .
5.
Two (2) Tool Operating and Maintenance
Instruction Manuals .
Series 416 tools are supplied complete with 2”
through 16” standard groove roll sets (with 8” to
12” rolls installed on the tool), unless otherwise
specified on the order . Check order and rolls on
tool to be sure . Rolls are marked with size and
part number for your convenience . For grooving
to other specifications and other materials, see
Tool Rating and Roll Selection chart on pages
29 and 30 . Grooving rolls for other specifications
and other materials must be purchased
separately .
TOOL SETUP
WARNING
• Do not connect power until instructed
otherwise.
Accidental start up of tool may result in
serious injury.
VE416FS
Before grooving, the tool head and legs must
be mounted on a Victaulic VPD752 or a Ridgid
300 power drive . The tool and power drive
must be placed on level ground and secured
to a platform or floor . See Operator Safety
Instructions Tool Setup on page 2 .
WARNING
• During tool set-up, one person cannot
safely handle the tool head assembly
because it weighs 150 lbs. At least two
people are needed to safely handle the
assembly. If a hoist is available, use it to
lift the tool head assembly into position.
Failure to follow this instruction may result
in serious injury.
1.
Remove all the components and check to be
sure all necessary items are included . See list
under Receiving Tool .
TM-VE416FS/FSD_6
TM-VE416FS/FSD
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A