LOWER ROLL
1.
Loosen and remove the bolt and retaining
plate as shown . Place on a clean surface .
2.
Slide the lower roll off the main shaft as
shown and store in the roll tote box supplied .
NOTICE
• Be careful not to lose the Woodruff Key.
It should remain in the lower shaft.
Inspect the Woodruff Key and replace if
damaged.
ROLL INSTALLATION 4 - 16”
Clean upper shaft, main shaft and lower roll
bore of any dirt and/or scale before installation
of rolls . Inspect the roller bearing inside upper
roll for proper lubrication and condition . Make
repairs as necessary .
LOWER ROLL
1.
Slide desired size lower roll fully onto main
shaft with the marked side facing forward as
shown . Make sure to properly align roll with the
Woodruff Key on main shaft . NOTE: To aid in
removing roll at a later time, you may apply a
thin film of oil or grease (anti-seize lubricant) to
the main shaft before installing the lower roll .
2.
Install lower roll retaining plate (marked
R-106-416-VEO) and bolt as shown . Securely
tighten bolt with a wrench .
UPPER ROLL
1.
Carefully slide desired size upper roll onto
upper shaft as shown with markings facing
forward .
TM-VE416FS/FSD_21
TM-VE416FS/FSD
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A