EXTENSION CORD
REQUIREMENTS
When pre-wired outlets are not available and an
extension cord must be used, it is important to
use the proper cord size (e .g ., conductor size
American Wire gauge) . Cord size selection is
based upon tool rating (amps) and cord length
(feet) . Use of a cord size (gauge) thinner than
required will cause a significant voltage drop at
the power drive or tool motor while the tool is
operating . The voltage drop may cause damage
to the power drive or tool motor and can result
in failure of the tool to operate properly . Use of
a heavier than necessary cord size (gauge) is
acceptable .
Listed in the chart below are recommended
cord size (gauge) for cord lengths up to and
including 100 feet . Use of extension cords
beyond 100 feet in length should be avoided .
Extension Cord Size (Gauge) Chart
Power
Drive
Power
Drive
Rating
Volt/Amps
Cord Lengths
25’
50’
100’
VPD752
115/15
12
12
10
Ridgid 300® 115/15
12
12
10
VE416FSD
115/15
12
12
10
® Registered trademark Ridge Tool Company
NOTICE
• Drawings and/or pictures in this manual
may be exaggerated for clarity.
TM-VE416FS/FSD_4
TM-VE416FS/FSD
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A