OPERATOR SAFETY
INSTRUCTIONS
This tool is designed only for roll grooving pipe .
To accomplish this function requires some
dexterity and mechanical skills, as well as sound
safety habits . Although this tool is manufactured
for safe dependable operation, it is impossible to
anticipate those combinations of circumstances
which could result in an accident . The following
instructions are recommended for safe operation
of the tool . The operator is cautioned to always
practice “Safety First” during each phase of use,
including setup and maintenance of this unit .
GENERAL
1. Read and understand this Manual before
operating or performing maintenance on this
tool.
Become familiar with the tool’s operations,
applications and limitations . Be particularly
aware of its specific hazards . Store this manual
in a clean area and always at a readily available
location . Additional copies at no charge are
available upon request by writing or phoning the
Victaulic Tool Company .
2. Use only recommended accessories.
Use of
improper accessories may be hazardous . See
Accessories on page 27 .
3. This tool is designed ONLY for roll grooving
of pipe sizes, materials and wall thicknesses
outlined under Tool Rating and Roll Selection,
pages 29 and 30.
TOOL SET-UP
1. Ground the power drive or tool.
Be sure
the power drive, used with the VE416FS or
the VE416FSD drive motor, is connected to an
internally grounded electrical system .
2. Avoid dangerous environments.
Don’t use the
tool in damp or wet locations . Don’t use the tool
on sloped or uneven ground or floor . Keep work
area well illuminated . Allow sufficient space to
operate tool and accessories properly and for
others to pass safely .
3. Prevent back injury.
During tool set-up,
one person cannot safely lift and handle the
VE416FS tool head assembly because it weighs
at least 150 lbs . Two people are needed to
safely lift and handle the assembly . If a hoist is
available, use it to lift the tool head assembly
into position
OPERATING TOOL
1. Inspect the equipment.
Prior to starting
the tool, check the movable parts for any
obstructions . Be sure that guards and tool parts
are properly installed and adjusted .
2. Prevent accidental startings.
Place switch on
the attached power drive (VE416FS only) in the
“OFF” position prior to plugging in unit .
3. Operate with foot switch only.
The power
drive (VE416FS only) must be operated with a
safety foot switch as the operator will require
it to operate the tool safely . If your power drive
does not have a foot switch, contact power drive
manufacturer . The VE416FSD comes equipped
with a safety foot switch .
4. Keep hands away from grooving rolls and
stabilizer wheel during grooving operation.
Grooving rolls can crush or cut fingers and
hands .
5. Never reach inside pipe ends during
operation.
6. Do not over-reach.
Keep your proper footing
and balance at all times . Be sure you can reach
foot switch safely at all times . Do not reach
across tool or pipe . Keep hands and loose tools
away from moving parts .
7. Wear safety glasses and footwear.
8. Keep work area clean.
Cluttered areas,
benches and slippery floors invite accidents .
9. Wear ear protection if exposed to long
periods of very noisy shop operations.
10. Keep visitors away.
All visitors should be
kept a safe distance from the work area .
11. Keep alert.
Do not operate tool if ill or
drowsy from medication or fatigue . Avoid
horseplay around tool and keep bystanders a
safe distance from tool and pipe being grooved .
TM-VE416FS/FSD_2
TM-VE416FS/FSD
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A
