2.
Install upper roll retaining plate and bolt . Align
tab on plate with recess in the slide as shown .
Securely tighten bolt with a wrench .
3.
Lubricate upper roll bearing with a No .
2EP Lithium base grease as shown . Refer to
maintenance section for additional information .
4.
Roll installation is complete .
ROLL INSTALLATION 2 - 31/2”
1.
Remove existing rolls if necessary . Refer to
4”-16” upper and lower roll removal procedures
(pages 20 and 21) .
2.
Lightly lubricate lower shaft with a thin film
of oil or grease before installing the lower roll .
Slide lower roll (Part No . R-902-416-L03) onto
main shaft . Make sure to properly align roll with
Woodruff Key on main shaft .
3.
Place 3/4” flat washer (Part No . N-W01-120-
000) onto 3/4” X 3/4” hex head cap screw (Part
No . N-S02-120-304) . Install bolt and washer as
shown . Securely tighten bolt with a wrench .
4.
Carefully slide upper roll assembly onto upper
shaft . Make sure to properly align the upper
support block with the recess in the slide as
shown .
5.
Thread the upper support block bolt (Part No .
R-902-416-M03) into the upper shaft as shown .
Tighten securely .
TM-VE416FS/FSD_22
TM-VE416FS/FSD
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A