Instruction Sheet
1
of 11
© 2016 TE Connectivity Ltd. family of companies.
All Rights Reserved.
*Trademark
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at
408-1602
10 NOV 16
Rev C
WIRE SIZE
(MCM)
(1)
CMA
(Circular Mil Area)
Range
Die Assembly PN
Single Crimp Dual Crimp
350
325,000-375,000
69653
---
350 HD
400
375,000-450,000
46754-2
---
500
450,000-550,000
46755-2
---
500
---
46756-2
(2)
600
550,000-650,000
---
46756-2
600 HD
59870-1
700
650,000-750,000
---
46757-2
800
750,000-850,000
---
46758-2
900
850,000-950,000
---
46759-2
1000
950,000-1,125,000
---
46760-2
1
MCM equals thousand circular mils
2
After crimping, product insulation will be embossed with 600
Figure 1
1.
INTRODUCTION
AMP* crimping die assemblies listed in Figure 1 are designed to crimp AMPOWER* terminals, parallel splices
and butt splices onto wire sizes 350 through 1000 MCM. The die assemblies are installed into Crimping Head
PN 69082 (Mod 1). The head is used with Hydraulic Power Units PN 69120-1 or 69120-2.
For information on tool setup and operation, refer to Instruction Sheet
Read these instructions carefully prior to installing, removing or using the dies.
NOTE
Dimensions in this instruction sheet are in millimeters [with inches in brackets]. Figures are not drawn to scale.
Reasons for re-issue of this instruction sheet are provided in Section 8, REVISION SUMMARY.
Crimping Die Assemblies 46754-2,
46755-2, 46756-2, 46757-2, 46758-2,
46759-2, 46760-2, 59870-1, and 69653
