15.
Insert the hand pump handle into lever
arm of the pump . Position handle with handle
grip down . Lock handle in this position with set
screw or nut and bolt provided .
DANGER
• To reduce the risk of
electric shock, check
the electrical source for
proper grounding and
follow the instructions
below.
• Before performing any repair or
maintenance, disconnect the tool from
the electrical source.
Failure to do so could result in death or
serious personal injury.
16.
Make sure power drive is in its “Off”
position (consult power drive manufacturer’s
instructions) . Plug the power drive into an
internally grounded electrical outlet . See
Operator Safety Instructions Tool Set-Up
on page 2 . The outlet must meet the power
requirements for the power drive (consult power
drive manufacturer’s recommendations) . See
page 4 for extension cord information, if used .
WARNING
• The power drive must be operated with
a safety foot switch, as the operator will
require it to operate the tool safely. If
your power drive does not have a foot
switch, contact power drive manufacturer.
17.
Turn the power drive switch to the position
that will produce clockwise rotation of the
chuck when viewed from the front of the tool .
On the Victaulic VPD752 and Ridgid 300,
putting the switch in the reverse position will
produce clockwise rotation of the chuck, lower
roll and pipe . Depress foot switch and check
rotational direction and tool stability . If rotation
is counterclockwise, reverse power drive switch .
If tool wobbles, check to make certain tool is
mounted squarely in chuck and tool is level .
If the wobble cannot be eliminated, the power
drive support arms are bent, or the power drive
is damaged . Take the necessary steps to have
power drive repaired if wobble persists .
18.
Disconnect power . Turn power drive switch
off or unplug power drive .
VE416FS tool setup is complete .
VE416FSD
WARNING
• Do not connect power until instructed
otherwise.
Accidental start up of tool may result in
serious injury.
1.
Remove all the components and check to be
sure all necessary items are included . See list
under Receiving Tools .
2.
Select location for tool, and pipe stand .
Choose a location that has:
a.
The required power . Consult Power
Requirements on page 3 .
b.
The space necessary to adequately handle
the pipe to be grooved .
c.
A level and even surface for power drive, tool,
pipe stand and footing .
TM-VE416FS/FSD_9
TM-VE416FS/FSD
OPERATING AND MAINTENANCE INSTRUCTIONS MANUAL
www.victaulic.com
VICTAULIC IS A REGISTERED TRADEMARK OF VICTAULIC COMPANY.
REV_A
