Vicon SVFT-C22, Инструкция по установке и эксплуатации

Страница: 29 / 80

Figure 13
Safety Cord Installation
12. Lift the SurveyorVFT camera drive up to the housing and attach
the housing’s safety cord clip to the camera drive’s tab. See
Figure 13. Allow the drive to hang from the housing. Insert the
clip of the safety cord from the lower dome into the hole on the
inside of the housing. See label inside housing.
13. Align the tabs on the camera drive with the slots in the housing,
matching up the arrows on the camera drive and the housing.
14. Push the camera drive straight up into the housing until it snaps
into the housing. Do not use excessive force. In the event that it
does not snap easily, remove the SurveyorVFT and verify
proper cabling.
15. Holding the lower dome, line up the 2 molded tabs on the lower
dome with the 2 parallel surfaces on the housing. Push the
lower dome up and verify that it snaps into place on both sides.
See Figure 14.
16.
Proceed to the Operation section of this manual.
Figure 14
Indoor Lower Dome Installation
XX134-07-00 Rev 908 SurveyorVFT Camera Dome System 4BInstallation
•
21