Vicon SVFT-C22, Инструкция по установке и эксплуатации

Страница: 57 / 80

XX134-07-00 Rev 908 SurveyorVFT Camera Dome System 7BUninstalling the SurveyorVFT
•
49
Uninstalling the SurveyorVFT
The ur S veyorVFT camera drive can be easily uninstalled by simply pushing in the tabs to release the camera
drive from the housing or the enclosure. A safety cord is always available to safely hang the camera drive or
camera dome assembly while installing or uninstalling.
For an In-Ceiling Installation
1. Gently pull down on the lower dome’s
ll
molded tabs snap out of place.
2. Push in the tabs to release the
camera drive from the enclosure. It
d. Refer
to Figure 25.
3. If it is necessary to completely remove
the camera drive, disconnect the
safety cord clip.
For a Pendant Installation
1. (Outdoor Pendant model only) Loosen
the 4 trim ring screws from the
outdoor lower dome.
2. Gently pull down on the lower dome’s
outside edge, until it snaps out of
place.
3. Push in the tabs on the housing until
the SurveyorVFT camera drive is
released. Refer to Figure 25.
4. Allow the SurveyorVFT to gently drop
down until it is supported by the safety
cord.
5. If it is necessary to completely remove the SurveyorVFT, disconnect the clip on the end of the safety cord
from the latch on the housing.
outside edge, with two hands, until a
will hang from the safety cor
Figure 25
Uninstallation