Vicon SVFT-C22, Инструкция по установке и эксплуатации

Страница: 65 / 80

XX134-07-00 Rev 908 SurveyorVFT Camera Dome System 9BCompetitive Protocols
•
57
Ultrak
When changing SurveyorVFT software addresses, the keypad may not respond to all 256 addresses. The
workaround is to go to Ultrak KEGS Setup menu, option (3.1.2) and set every camera (256) to KD6.
Function Keypress Function Keypress
Enter Menu
Enter SVFT-M address on keypad and hit Enter
key. Use LCD softkeys to navigate to Main
Menu. Use Focus Far to select and save, Iris
Close to abort and exit, Joystick up and down to
navigate, button 1 for AUX1, button 2 for AUX2
Set Transmit Polarity Not supported
Select/Store
When in SVFT-M Preset 94 menu use Focus
Far Program
Sectors
To Program sectors go to soft key menu and
select Sector Menu. It will enter SVFT-M Preset
96 menu. Use button 1 for AUX 2 and button 2
for AUX3, Focus Far to select and save and Iris
Close to abort and exit.
Backup/Abort/Exit
When in SVFT-M Preset 94 menu use Iris Close
Reset Dome Not supported
Iris Open Iris Open Set AP limits Not supported
Iris Close Iris Close Set Pan limits Not supported
Focus Near
Focus Near
Diagnostic Screen
Not supported
Focus Far Focus Far Debug Screen Not supported
Zoom Out Twist joystick counterclockwise Preset Tours
Internal dome tours are programmed using SVFT-
M Preset 94 menu system. To run tours 80
through 87, go to Ultak soft key menu and select
Vector/ Run option. Once prompted to enter
vector number, use number 0 to call tour 80, 1 to
call tour 81…, and 7 to call tour 87. Hit Enter.
Zoom In Twist joystick clockwise Auto Tour
Internal dome autotours are programmed using
SVFT-M Preset 94 menu system. To run
autotours 88 and 89, go to Ultrak soft key menu
and select Tour/ Run option. Once prompted to
enter tour number, use number 1 to call tour 88
and 2 to call tour 89 . Hit Enter.
Camera Off Not supported Night Mode- Manual
Night mode is enabled or disabled by using Night
mode soft key button. All other Night mode
features are accessible using SVFT-M Preset 94
menu.
Camera On Not supported Alarms
If the user wants to use the alarms they must be
acknowledged from within the dome.
Autopan Not supported Alarm Acknowledge Not supported
Autoiris Use Auto Iris soft menu key on the keypad Flip (Turn 180 degrees) Not supported
Lens Speed Not supported
Camera Control
Including Adjust
V-Phase
Menu system
Auxs Not supported
Backlight
Compensation
Use Auxiliary button. In order to work it needs to
be enabled in SVFT-M Preset 94 menu.
Presets
Presets 1-64 only are supported. Presets are
captured and configured using SVFT-M Preset
94 menu. To recall a preset enter preset
number on keypad and hit View button.
Pan and Tilt Lockout Not supported