Vicon SVFT-C22, Инструкция по установке и эксплуатации

Страница: 23 / 80

The accessory kit contains the removable screw
terminal blocks to be used for all connections in
this installation.
Figure 6
Unlatching the Customer Interface Board
The ceiling material must provide a surface of
suitable strength for the SurveyorVFT weight of
5.1 lb (2.3 kg) on the area of the two flippers.
Refer to the
Optional Independent Support sub-
section for installations requiring additional
support.
1. Mark, with the scribe, and cut a 7-3/8-inch
(187 mm) diameter hole in ceiling at the
desired location. Feed all flexible conduit
pipe or cables down through the hole.
2. Unlatch the customer interface board and swing it 90º downward, providing access to terminal blocks.
Refer to Figure 6. (The board can be completely removed, if necessary, by snapping it out of the hinge
after rotated to the 90º downward position.)
3. If cables are used without the use of flexible conduit:
a) Remove the conduit fitting by loosening the nut and sliding it out. Install the supplied strain relief
fitting in its place.
b) Hold the enclosure near the hole in the ceiling and route cables through the strain relief fitting.
3. If cables are channeled through flexible conduit:
a) Hold the enclosure near the hole in the ceiling and route conduit cables through the conduit fitting.
b) Insert the end of the flexible conduit pipe into the conduit fitting. Cable length should be flush with the
bottom of enclosure, approximately 9 inches (229 mm). Tighten the clamp screw.
4. Lift enclosure up through ceiling hole, turn and tighten flipper screws.
5. Remove terminal blocks from the accessory kit. The 2-pin is for power, the two (2) 8-pin are for alarms
and control/relay; the 3-pin is for UTP option.
XX134-07-00 Rev 908 SurveyorVFT Camera Dome System 4BInstallation
•
15