Vicon SVFT-C22, Инструкция по установке и эксплуатации

Страница: 64 / 80

56
•
9BCompetitive Protocols XX134-07-00 Rev 908 SurveyorVFT Camera Dome System
Kalatel
Function Keypress Function Keypress
Enter Menu
Press Set until "Enter Programming Code"
appears. Enter Access Code 951followed by
SEQ. Select 4 - Cyberdome. Enter three digit
camera number. Enter 1 when prompted
"Does The Monitor Display Site XXX".
Program the unit using the joystick.
Set Transmit Polarity Not Supported
Select/Store Set key Program Sectors
Not Supported; privacy masks through the
menu system is supported
Backup/Abort/Exit
"1st key" (backs up one menu) or "Hold SEQ
(3 sec) to Exit" (exits entire menu system)
Reset Dome Not Supported
Iris Open
Iris Open - Controls autoiris setting (Dome
must be set for keypad, autoiris adjust
enabled)
Set AP limits
Set presets 62 (left) and 63 (right) using the
menu system
Iris Close
Iris Close - Controls autoiris setting (Dome
must be set for keypad, autoiris adjust
enabled)
Set Pan limits Not Supported
Focus Near
Focus Near (Auto Focus key sets dome back
to auto focus)
Diagnostic Screen Not Supported
Focus Far
Focus Far (Auto Focus key sets dome back to
auto focus)
Debug Screen Not Supported
Zoom Out Zoom Out Preset Tours
Internal preset tours 80 and 81 mapped to tours
3 and 4. Tours are programmed using the menu
system. To execute a tour press "Set" followed
by "Auto". Enter 3 or 4.
Zoom In Zoom In Auto Tour
Internal dome auto tours 88-89 mapped to tours
1 and 2. Tours are programmed using the menu
system. To execute a tour press "Set" followed
by "Auto". Enter 1 or 2
Camera Off
Tested using a terminal program. The KTD-
404 does not support this command.
Night Mode- Manual
Tested using a terminal program. The KTD-404
does not support this command.
Camera On
Tested using a terminal program. The KTD-
404 does not support this command.
Alarms
Programmed through the menu system. Kalatel
keypads do not support alarms or alarm
acknowledge from a dome; alarms must be
acknowledge from within the dome.
Autopan
Auto (AP limits set using presets 62 and 63
from menu system)
Alarm Acknowledge Not Supported
Autoiris No Control - Unit is always in autoiris
Turbo (Set speed to
full) - (Pelco Feature) Not Supported
Lens Speed Not Supported
Flip (Turn 180
degrees) Tested using a terminal program. The KTD-404
does not support this command.
Auxs
Open button on the keypad turns AUX off.
Closed button turns AUX on. If set to
momentary pressing closed turns AUX on
releasing Close turns AUX off.
Peel (Sensormatic
Feature)
Not Supported
Presets
Presets 000-063. Preset 000 not supported.
Presets 1-063 programmed using menu
system. The VFT also supports preset store
but the KTD-404 does not support this
command. The store command was tested
using a terminal program.
Camera Control
Including Adjust
V-Phase
Menu system
Pan nd Tilt Lockout Not Supported a