ViaSat Business Hotspots, Руководство по установке

Страница: 43 / 43

Viasat Business Hotspots Installation Guide
Page | 43
Step 5 | Insert wires
Holding the RJ45 connector so that its pins are
facing away from you and the plug-clip side is
facing down, carefully insert the flattened,
arranged wires into the connector, pushing
through until the wire ends emerge from the
pins. For strength of connection, also push as
much of the cable jacket as possible into the
connector.
Step 6 | Confirm proper formation
Check to make sure that the wire ends coming
out of the connector's pin side are in the
correct order; if not, remove them from the
connector, rearrange into proper formation,
and re-insert. Remember, once the connector
is crimped onto the cable, it's permanent. If
you realize that a mistake has been made in
wire order after termination, you'll have to cut
the connector off and start over.
Step 7 | Crimp plug
Insert the prepared connector/cable assembly
into the RJ45 slot in your crimping tool. Firmly
squeeze the crimper's handles together until
you can't go any further. Release the handles
and repeat this step to ensure a proper crimp.
Step 8 | Repeat
After the first termination is complete, repeat
process on the opposite end of your cable.
View online at http://www.cableorganizer.com/learning-center/how-to/how-to-terminate-RJ45.htm