ViaSat Business Hotspots, Руководство по установке

Страница: 42 / 43

Viasat Business Hotspots Installation Guide
Page | 42
Terminating Ethernet cable
This section outlines step-by-step procedures for terminating Ethernet cable using a crimping tool, UTP cable
stripper, and RJ45 connector. Also see the Ethernet Cable Prep Job Aid located in the eGuide .
Step 1 | Trim cable
Using a crimping tool, trim the end of the cable
you're terminating to ensure that the ends of
the conducting wires are even.
Step 2 | Strip jacket
Being careful not to damage the inner
conducting wires, strip off approximately 1
inch of the cable's jacket, using a modular
crimping tool or cable stripper.
Step 3 | Separate wires
Separate the 4 twisted wire pairs from each
other, and then unwind each pair, so that you
end up with 8 individual wires. Flatten the
wires out as much as possible, since they'll
need to be very straight for proper insertion
into the connector.
Step 4 | Arrange wires
Holding the cable with the wire ends facing
away from you. Moving from left to right,
arrange the wires in a flat, side-by-side ribbon
formation, placing them in the following order:
white/orange, solid orange, white/green, solid
blue, white/blue, solid green, white/brown,
solid brown.