ViaSat Business Hotspots, Руководство по установке

Страница: 34 / 43

Viasat Business Hotspots Installation Guide
Page | 34
Installation instructions
Before installing the indoor Access Point (AP), determine which mount type to use: drop-ceiling T-bar (most
common), flat surface, or mounting bracket; then mount the AP. The AP can be removed, if needed, for
troubleshooting or replacement.
Mount the AP on a drop-ceiling T-bar
Figure 4: T-bar mount
1 Orient the AP so that the T-bar is positioned between the T-bar clips as
shown. The top of the AP (blank white part) will face the floor.
2 Rotate the AP until the third T-bar clip catches the T-bar and the latch
locks the T-bar in place.
Optional: For added security, using a Torx T8 screwdriver, insert the
locking screw (A) into the hole near the latch to lock the AP in place.
Remove the AP from a drop-ceiling T-bar
1
To remove the AP, first remove the security screw (if used), then
depress the latch while rotating the AP so that the T-bar clips
disengage the T-bar.
Mount the AP on a flat surface
Figure 5: Flat-surface mount
1 Use the Mounting Template (located at the end of the Indoor AP
section of this guide) to mark the locations for two drill holes on the
mounting surface.
2
Use a 4.75mm (3/16”) drill bit to drill holes approximately 25mm (1”)
deep into the mounting surface.
3 Insert the factory-supplied anchors (A) and mounting screws (B) into
the mounting surface, leaving approximately 6mm (1/4”) of the screw
heads protruding from the surface.
4 Place the AP onto the mounting screws so that the screw heads enter
the keyholes on the AP enclosure (C), and gently press down on the AP
until the locking tab in the upper AP keyhole locks the AP onto the top
mounting screw.
Remove the Access Point (AP) from flat-surface mounting screws
1
To remove the AP from the factory-supplied mounting screws, gently
press the unit removal pin (A) into the access hole on the end of the AP
to release the bracket locking tab in the upper keyhole.
2 Push the AP up and pull it away from the mounting screw heads.