ViaSat Business Hotspots, Руководство по установке

Страница: 35 / 43

Viasat Business Hotspots Installation Guide
Page | 35
Mount the AP using secure mounting bracket
Figure 6: Mounting bracket
The included Mount Kit includes a metal mounting bracket and provides
greater security when attaching the AP to flat surfaces (walls and ceilings) and
poles.
When using the mounting bracket, you will need an electric drill with a
4.75mm (3/16”) drill bit, and the four No. 6 zinc-plated screws and plastic wall
anchors included with the kit.
If you are mounting the AP on a truss or pole, then you will also need the two
installer-supplied stainless steel pipe clamps.
1 If mounting on a flat surface, use the secure mounting bracket as a
template to mark the locations for four drill holes on the mounting
surface. There are four screw holes available on the secure mounting
bracket.
Fasten the bracket to the flat surface using four mounting screws and
plastic wall anchors.
Continue with Step 3.
2 If you are mounting the AP on a pipe or pole, then feed the two
installer-supplied stainless steel clamps through the slots on the
secure mounting bracket. Use common hand tools to tighten the
clamps around the pipe or pole.
After the bracket is attached, continue with Step 3.
3 Insert the two studs on the secure mounting bracket (A) into the
keyholes on the bottom of the AP.
4
Slide the AP toward the Ethernet port until the locking tab in the upper
AP keyhole locks the AP onto the top mounting bracket stud.
Remove the AP from the secure mounting bracket
1
Gently press the unit removal pin (A) into the access hole on the end of
the AP to release the bracket locking tab in the upper keyhole.
2
Slide the AP toward the unit removal pin and remove the AP from the
bracket.