ViaSat Business Hotspots, Руководство по установке

Страница: 12 / 43

Viasat Business Hotspots Installation Guide
Page | 12
Modem to controller
NOTE:
If the customer already has Business Voice,
skip this step. Proceed to
Controller to PoE Injector
.
1 Place the controller near the satellite modem.
2
Connect the blue Ethernet patch cable from the
modem to Port 1 on the controller.
NOTE:
When using the SB2+ modem, the controller
must be plugged in to Port 1 (next to the white phone
port). The other ports will not work.
3 Plug in the power cable from the controller into the
power source.
OR
Controller to PoE injector
1 Connect one end of a yellow Ethernet patch cable into
one of Ports 2-5 on the controller.
2
Then connect the other end into the LAN port on the
PoE injector Repeat this step for each additional PoE
Injector.
PoE injector to indoor AP
1 Connect one end of the standard CAT5e Ethernet
cable into the POE port on the PoE injector.
2
Then connect the other end of the Ethernet cable into
the POE IN Ethernet port on the back of the AP.
3 Plug the PoE injector/s into the power source.
4
After boot-up, verify that the PWR LED on the AP is a
steady green.
5 Repeat this step for each additional AP.
PoE injector to outdoor AP
1
Connect one end of the outdoor-rated Ethernet
cable into the POE port on the PoE injector.
2 Then connect the other end to the cable through
the cable gland assembly to the Ethernet port on
the front of the AP. (See Step 1 of the Outdoor AP
installation instructions on page 25.)
3 Plug the PoE injector/s into the power source.
4 After boot-up, verify that the PWR LED on the AP is a
steady green.
5 Repeat this step for each additional AP.
Step 6 | Auto-configure equipment
The controller and AP/s are set up to automatically configure and register with Viasat through the Installer
Portal. To initiate this process, the MAC Address of the controller must be entered into the Installer Portal,
which triggers discovery of the equipment.