ViaSat Business Hotspots, Руководство по установке

Страница: 26 / 43

Viasat Business Hotspots Installation Guide
Page | 26
Installation instructions
Step 1 | Connect and seal Ethernet cable
The AP uses one RJ45 (Ethernet) cable for Power over Ethernet (PoE). Connect and seal the cable using the
M25 data cable gland (B in Figure 1). normally
1 Use a wide flat-blade screwdriver to remove the blanking cap from the AP.
Feed the end of the RJ-45 (Ethernet) cable through the sealing nut, rubber O-ring, clamping ring
assembly and cable gland base.
Do not seat the clamping ring and rubber O-ring into the gland body
until the gland body has been torqued.
Figure 3: RJ-45 cable and cable gland assembly
2 Connect the cable to the Ethernet port in the AP.
3 Tighten the cable gland base into the AP chassis until secure.
4
Wrap the clamping ring assembly around the rubber O-ring. Make sure that the clamping ring
assembly fully encloses the rubber O-ring.
5 Seat the clamping ring assembly and rubber O-ring in the cable gland base.
6 Hand tighten the sealing nut.
7
Continue with Step 2a | Attach mounting bracket to a flat surface or Step 2b | Attach mounting bracket
to metal pole.
Step 2a | Attach mounting bracket to flat surface
1
The AP mounting bracket attaches to the AP using a captive screw. Use a medium flat-blade or No. 2
Phillips screwdriver to loosen the captive screw (A in Figure 4) and pull up on the end of the bracket to
remove the bracket from the AP (B in Figure 4).
Figure 4: Removing the mounting bracket