ViaSat Business Hotspots, Руководство по установке

Страница: 24 / 43

Viasat Business Hotspots Installation Guide
Page | 24
Overview
This section provides step-by-step instructions on how to install the Ruckus Wireless Outdoor Access Point.
Package contents
»
One outdoor AP (A in Figure 1); includes
one wall- or pole-mounting bracket and
one 12mm M6x1 earth ground screw with
split lock and flat washers
»
One M25 data cable gland (B in Figure 1)
»
Ground wire with lug (C in Figure 1)
»
Pole/wall mount bracket kit (D in Figure 1)
»
Four steel pipe clamps
Figure 1: AP field-installation package contents
Setup requirements
»
Torque wrench or torque screwdriver with
sockets and bits
»
Small flat-blade screwdriver
»
No. 2 Phillips screwdriver
»
Long-nose pliers
»
Wire stripping and terminal crimping pliers
»
Outdoor-rated CAT5e Ethernet cable
»
Electric drill with drill bits and installer-supplied
wall anchors, flat washers, and hex nuts for flat-
surface mount
»
Pipe/pole or sturdy flat surface
Important safety information
Warning:
Installation of this
equipment must comply with
local and national electrical
codes.
Warning:
Ruckus Wireless
strongly recommends that you
wear eye protection before
mounting the AP.
Caution:
Make sure that you form a 3in – 5in drip loop in any cable that is attached
to the AP or the building. This will prevent water from running along the cable and
entering the AP or the building where the cable terminates.
Caution:
Be sure that grounding is available and that it meets local and national
electrical codes.
Caution:
Make sure that proper lightning surge protection precautions are taken
according to local electrical code.