28
20306744
WDV Series Gas Fireplace
FINAL INSTALLATION
STONE & GLASS PLACEMENT
1. For best results, spread glass evenly over the entire
floor and burner making sure the glass is not too heavy
over the burner ports (single layer only). Keep rear vent
area open to allow air to circulate under the stones.
Figure 39
2. Place the stones randomly in front of and behind the
burner ports. CAUTION: Do not allow stones to sit
directly on burner ports or in flame.
Figure 39
3. Turn burner on and adjust glass over the ported area to
achieve an even, clean flame.
4. Replace glass frame and access door in reverse order
of removal.
Figure 39 -
Stone Placement
FP2434
stone placement
Firebox
Perimeter
Burner Surface
Rear Vent
Example of Stone
Placement
FP2702
rock and stone place
GLASS ONLY PLACEMENT
NOTE: Two (2) bags of glass are supplied with the 500
Series fireplaces. Both bags should be used to cover
the entire floor and burner. Three (3) bags of glass are
supplied with the 600 Series fireplaces. It is not necessary
to use the entire 3rd bag of glass provided. Too much
glass can cut off the proper amount of air the burner
needs to burn clean. This may cause sooting.
1. Spread glass evenly in one layer over the entire floor
and burner. It is important to not have the glass too
heavy on ported area (single layer only). Keep rear
vent area open to allow air to circulate for a clean
flame and appearance.
2. Turn burner on and adjust glass over ported areas to
achieve an clean flame.
3. Replace glass frame and access door in reverse order
of removal.
LIGHT INSTALLATION
1. Remove the front floor screen frame by unfastening
the four (4) screws securing the front and sides.
2. Install the six (6) halogen light bulbs provided. Do not
touch light bulbs directly with fingers.
3. Replace the front floor screen frame. Be sure wires do
not get pinched below the light channel.
Screws
FP2434
replace light bulbs
Floor Screen
Frame
Halogen Light
Bulbs
Figure 38 -
Install Light Bulbs
