91
OPERATING THE REFRIGERATOR CONTROLS
Control Panel:
Control for the refrigerator is a single switch on center, front panel to
turn unit ON or OFF. Should you wish to change temperature on the
inside of box you must move the thermister and wire on the fins of
unit.
To turn refrigerator off, just turn the switch to off.
The refrigerator control panel is between the freezer compartment
and the fresh food compartment. A 12 volt DC power supply is
necessary for the control functions of the refrigerator to operate. The
refrigerator receives DC power from the 12 volt system of the vehicle;
either an auxiliary battery, a convertor, or the vehicle engine battery.
For full operation details of all of the buttons and it’s function on the
control panel, refer to the Norcold refrigerator owners manual.
_MONITOR PANEL______________________________________
Your panel through modern technology will supply the charge
condition of your battery, and water level information from your water
tanks.
Operation requires 12-volt DC power, supplied by the battery or
converter. Sensors, one negative and three positive, attached to a
resistor feed information to the display panel. To operate, place
finger on button and push. A
light will illuminate indicating
the water level of tanks or
charge condition of battery.
“ Gallery “ will light only
when floor plan includes the
second gray water holding
tank.
The switch on the lower left
corner is for water pump
operation. When in the “ON”
position, pump will run until
40 to 45 PSI is achieved.
The pump will shut off and
restart at 20 pounds of
pressure. Turn pump switch
PDF created with pdfFactory trial version
www.pdffactory.com
