81
From the time you turn the thermostat on, there is a delay built into
the furnace to perform a purge cycle preventing any possible gas
vapor build-up in the chamber.
NOTE:
Different model furnaces are used for different unit floor
plans. Each model furnace has it’s own Users Manual. The following
instructions may vary slightly from the instructions in your unit.
Therefore very important that you refer to the Users manual
provided in your unit.
Operating Instructions
1. Before using your furnace, it is suggested to open entrance
door and windows to ventilate camper for any unusual odors
such as propane or other.
2. Be sure propane container has fuel and valve is open.
3.
Release thermostat from OFF position and onto HEAT position.
4.
Set temperature on 5 to 8 degrees above room temperature.
5. Blower will start in 0 to15 seconds, run for 30 seconds during
heat chamber PURGE cycle, removing any propane vapor.
6. Second cycle, blower continues to run, module board will: (a)
send spark to the burner tube, (b) Open valve to release
propane to burner tube.
7
. Ignition attempt will be for 7 seconds.
8. Failing to ignite, board will make 2 more attempts to light the
burner and then go to lockout.
9.
If after (3) attempts with no ignition, drop thermostat to lowest
setting, wait 1 minute and repeat the same steps.
10.
After the burner tube lights, set thermostat at desired setting.
11.
To shut burner down, move thermostat to lowest setting or to
OFF.
12.
Blower will continue to run for about 2 minutes until heat is
removed from chamber.
To Turn Off Appliance
1. Set the thermostat to lowest setting, then move lever to “ OFF “
position.
2. Turn off all electric power to the appliance if service is to be
preformed.
3. Turn manual valve ( if so equipped ) to the “ OFF “ position. Do
not force.
External Vents.
Always be sure these vents are clear of any
objects like screens, duct tape, etc. Exhaust will be hot after
operation.
PDF created with pdfFactory trial version
www.pdffactory.com
